Poland Moulding: Softeners Removed, Cycle Time Cut

Home 9 Case Studies and Results 9 Poland Moulding: Softeners Removed, Cycle Time Cut
Key results
0 water softener use
Improved cycle time
1 month cleaning interval

Summary

Cycle time came down, the ion exchange softeners were disconnected after installation and rotometer cleaning became less frequent. Mineral and biofilm deposits were reduced across the cooling system, and removing the softeners also reduced water use and regeneration costs.

Case Study from Hydropath Poland

Injection moulding cycle time and cooling channel scale

Injection moulding cycle time was stretching at a Polish plant because scale and biofilm in the mould cooling channels were cutting heat transfer. Rotometers needed cleaning every month, and cycle time and operating costs had increased. In July 2017 two HydroFLOW® P120 units and one S38 were fitted to the cooling circuits and the heat exchanger, on 114 mm and 30 mm pipe. Scale and biofilm deposits were reduced, cycle time came down, rotometer cleaning became less frequent and the ion exchange softeners were removed.

The Challenges

  • Injection moulding cycle time was stretched by scale and biofilm in the cooling channels
  • Reduced heat transfer was lengthening cycles and pushing up operating costs
  • Rotometers needed cleaning every month

The Solution

  • Units installed: two HydroFLOW® P120 and one S38
  • Installation point: cooling circuits and heat exchanger
  • Pipe size: 114 mm and 30 mm
  • Installed: July 2017
  • Previous treatment: ion exchange softeners, since removed

The two P120 units and the S38 were fitted to the cooling circuits and the heat exchanger. HydroFLOW® treatment reduced mineral and biofilm deposits, and the ion exchange softeners were disconnected after installation. Injection moulding cycle time fell as improved heat transfer increased cooling efficiency.

Key Outcomes

R

Scale and biofilm reduced across the system

R

Improved heat transfer and cooling

R

Ion exchange softeners disconnected

R

Injection moulding cycle time reduced

Independent Verification

All results in this study were measured and verified by third-party facilities managers and technical staff.

Ready to see more?

Ready to explore sustainable water treatment?

Get in touch to find out how HydroFLOW® can work for you.

© 2026 Hydropath Technology Ltd. All rights reserved