Case Study from HydroFLOW USA The Challenge Quarterly tests showed Legionella above the 1 CFU/mL target Average contamination level reached 7 CFU/mL Flushing and equipment replacement were expensive A $75,000 treatment system was being considered The Solution A...
Case Study from HydroFLOW Chile The Challenge Mussels and marine organisms built up inside suction lines Blockages reduced flow and affected operational efficiency Frequent maintenance was needed due to fouling regrowth Chemical dosing risked higher cost and...
Case Study from HydroFLOW Italy The Challenge Water hardness of approximately 840 ppm CaCO₃ Scaling risk to RO membranes Chemical dosing required for control Risk to pipes, tanks and equipment The Solution One HydroFLOW® iCustom 16″ unit was installed in May...
The Challenge Shutdowns every 3–4 months for acid cleaning Reduced thermal efficiency in heat exchangers Safety risks from chemical handling Seal and gasket wear from cleaning agents The Solution Two HydroFLOW® units — a Pearl Plus on the make-up water line and an...
Case Study from HydroFLOW USA The Challenge Scale persisted despite softening and chemicals Heavy scale coated internal boiler tubes Acid cleaning was being considered Heat transfer efficiency was reduced by scale The Solution One HydroFLOW® i45 unit was installed on...
